Audio Technica ATM350PL microfono con sistema di montaggio c

Altri clienti hanno comprato anche

Audio Technica ATM350PL microfono con sistema di montaggio clip on Codice prodotto: 9000-0030-1603 Termini di garanzia: Su questo prodotto avrete una garanzia di 2 anni.

Descrizione

The ATM350PL system consists of the ATM350a clip-on condenser microphone and the 22.9cm-long ATM350P magnetic mounting clip. The microphone is especially designed for instruments with a very wide dynamic range, and has an maximum SPL of 159 dB. This means the high frequencies in particular will remain intact. Brass wind instruments, snare drums, toms, percussion, violins, and pianos in particular can be captured with great accuracy with the ATM350a.

Cardioid pickup pattern and high-pass filter

Thanks to the cardioid directional characteristic of the ATM350a that filters out sound from the sides and rear of the audio source, the captured sound is crystal clear. It also features a high-pass filter that keeps low-frequency noise under control. The ATM350PL also includes a AT8468 violin mounting clip so you can use it with other instruments as well.

Specifiche

Caratteristiche

Ingresso bodypack UniPak / Hirose 4p
Sensibilità microfono (dB/PA) -49
SPL massimo 150 - 159 dB
Frequenza massima 20 - 20,9 kHz
Frequenza minima 40 - 49 Hz
Direttività cardioide
Ideale per strumenti a fiato, contrabbasso / violoncello / violino, rullante / tom / percussioni, pianoforte

Peso e dimensioni imballaggio incluso

Peso (imballaggio incluso) 500 gr
Dimensioni (imballaggio incluso) 31,5 x 15,0 x 8,5 cm

Specifiche

instrument microphone
capsule: condenser (permanently polarized)
pickup pattern: cardioid
frequency response: 40 - 20,000 Hz
high-pass filter: 80 Hz, 12 dB
sensitivity: -49 dB (3.5 mV) 1V @ 1 Pa
impedance: 200 ohms
max. sound pressure level (SPL): 159 dB, 1 kHz @ 1% THV
dynamic range: 130 dB, 1 kHz @ max. SPL
signal-to-noise ratio: 65 dB, 1 kHz @ 1 Pa
phantom power supply: 11 - 52V / 3.5 mA
switch: neutral, roll-off
mic weight: 14.5 g
power module weight: 90 g
microphone dimensions: 37.8 mm
max. body diameter: 12.2 mm
power module dimensions: 92 mm (length)
18.9 mm (diameter)
output connector: 3-pin male XLR
cable:
- length: 4 m (permanently attached to microphone)
- diameter: 3.2 mm
- type: HIROSE HR10 (shielded)
box contents:
- ATM350a cardioid condenser microphone
- AT8543 power module
- AT8491P UniMount universal clip-on mounting system
- AT8490L UniMount 9-inch gooseneck
- AT8468 violin clip
- M36 protective carrying bag

To view this/these video(s), you'll need to accept the marketing cookies.

Recensioni

La tua opinione

Per questo prodotto non ci sono ancora recensioni.